HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 160)

160 smart.Turn units
2.1
1
Units—Special oper
ations
"Defaults" form
GWW
Tool change point
 No axis (do not approach the tool change point)
 0: Simultaneous (X and Z axes depart diagonally)
 1: First X, then Z
 2: First Z, then X
 3: Only X
 4: Only Z
 5: Only Y
 6: Simultaneous with Y
CLT Coolant
 0: Without
 1: Circuit 1 on
 2: Circuit 2 on
G60 Protection zone (default for drilling units)
 0: Active
 1: Inactive
Cycle form
L
Subprogram name: Name of a subprogram that is called by
the start unit
"Global" form
G47
Safety clearance
SCK Safety clearance in infeed direction (drilling and milling)
SCI Safety clearance in the working plane (milling)
I, K Oversize in X, Z direction (X: diameter value)
You can load the zero point shift and the tool change point
by soft key (see soft-key table).
 The setting in the "TC point" form applies only within the
current program.
 Position of tool change point (WX1, WZ1, WY1):
 If the tool change point is defined, you use G14 to
move to this position.
 If the tool change point is not defined, you use G14 to
move to the position defined in manual mode.
If you call a subprogram using the start unit, you should set
the subprogram with G65 Chuck selection with fixture D0.
You should also move the C axes out, for example with
M15 or M315.