HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 137)

HEIDENHAIN MANUALplus 620, CNC PILOT 640 137
2.9 Units—Milling, f
a
ce
"Face milling ICP" unit
The unit mills the contour defined with ICP on the face of the
workpiece.
Unit name: G797_ICP / Cycle: G797 (see page 355)
Access to the technology database:
 Machining operation: Finish milling
 Affected parameters: F, S, FZ, P
Contour form
FK
see page 62
NS Starting block no. of contour
Z1 Milling top edge
Z2 Milling floor
X2 Limit diameter
Cycle form
QK
Machining operation
 Roughing
 Finishing
J Milling direction
 0: Unidirectional
 1: Bidirectional
H Cutting direction
 0: Up-cut milling
 1: Climb milling
P Maximum infeed
I Contour-parallel oversize
K Infeed-direction oversize
FZ Infeed rate
E Reduced feed rate
U Overlap factor
Further forms: see page 60