HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 6)

6
New functions of software 68894x-03 and
54843x-03
 The parameter WE was added to G32 (see „Single thread cycle
G32” on page 307)
 The parameters U, V and W were added to G51, G56 and G59 (see
„Zero point shifts” on page 259)
 Parameters ensuring maximum compatibility with the ICP contour
description were added to G0, G1, G12/G13, G101, G102/G103,
G110, G111, G112/G113, G170, G171, G172/G173, G180, G181 and
G182/G183 (see „Basic contour elements” on page 201) (see
„Front and rear face contours” on page 230) (see „Lateral surface
contours” on page 239) (see „Contours in the XY plane” on page
504) (see „Contours in the YZ plane” on page 513)
 The parameter C was added to G808 (see „Hobbing G808” on page
543)
 The parameter U was added to G810 and G820 (see „Contour-
based turning cycles” on page 270)
 The parameter D was added to G4 and G860 (see „Recessing
G860” on page 283) (see „Period of dwell G4” on page 381)
 The parameter B was added to G890 (see „Finish contour G890” on
page 290)
 The parameter RB was added to the units G840 "Contour milling,
figures" and G84X "Pocket milling, figures" (see „The Global form”
on page 64) (see „"Contour milling, figures, face" unit” on page 139)
(see „"Pocket milling, figures, face" unit” on page 142) (see
„"Contour milling, figures, lateral surface" unit” on page 151) (see
„"Pocket milling, figures, lateral surface" unit” on page 154)
 The parameters SP and SI were added to all tapping units (see
„Units—Centric drilling” on page 80) (see „Units—Drilling in C axis”
on page 84) (see „"ICP tapping, Y axis" unit” on page 169)
 G48 was introduced to allow limiting the rapid traverse rate for
rotary and linear axes (see „Reduce rapid traverse G48” on page
253)
 G53, G54 and G55 were introduced for zero point shifts using offset
values (see „Zero point offsets—Shift G53/G54/G55” on page 261)
 The functions for superimposing axis movements G725 "Eccentric
turning", G726 "Transition to eccentric" and G727 "Eccentric X" were
introduced (see „Eccentric turning G725” on page 399) (see
„Transition to eccentric G726” on page 401) (see „Eccentric X
G727” on page 403)
 The load monitoring functions G995 "Monitoring zone definition" and
G996 "Type of load monitoring" were introduced (see „Monitoring
zone G995” on page 388) (see „Load monitoring G996” on page
389)
 The AWG submode now also supports tools with quick-change
holders (see „Tool selection, turret assignment” on page 566)
 A tree view is available in the smart.Turn operating mode (see
„Editing with active tree view” on page 40)
 Skip levels can be defined in the smart.Turn operating mode (see
„Skip level” on page 426)