HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 557)

HEIDENHAIN MANUALplus 620, CNC PILOT 640 557
7.
2 A
u
to
matic w
o
rk
ing plan g
e
ner
a
tion (A
WG)
Editing the machining sequence
Select "Edit line."
"OK" confirms the new machining sequence.
Deleting a machining operation
"Delete line" deletes the selected machining sequence.
Overview of machining sequences
The following table lists the possible combinations of main machining
operations with submachining operations and machining locations and
explains the working method of the AWG.
Machining sequence for predrilling
Machining sequence for roughing
Main machining Submachining Location Execution
Predrilling Contour analysis: Determining the drilling steps
Machining parameter: 3 – Centric predrilling
All – Predrilling
Main machining Submachining Location Execution
Roughing Contour analysis: Dividing the contour into areas for longitudinal/
transverse outside machining and longitudinal/transverse inside
machining according to the transverse/longitudinal ratio.
Sequence: First outside, then inside machining
Machining parameter: 4 – Roughing
All – Transverse machining, longitudinal machining—outside and inside
Longitudinal
machining – Longitudinal machining—outside and inside
Longitudinal
machining Outside Longitudinal machining—outside
Longitudinal
machining Inside Longitudinal machining—inside
Transverse
machining – Transverse machining—outside and inside
Transverse
machining Outside Transverse machining—outside
Transverse
machining Inside Transverse machining—inside