HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 310)

310 DIN Programming
4.1
9
Thr
ead cy
cles
Activating handwheel during G33
With the G923 function you can activate the handwheel in order to
make compensations during a thread cut. In the G923 function you
define limits within which traverse with the handwheel is possible.
 Cycle stop—the Steuerung retracts the tool from the
thread groove and then stops all tool movements. (Lift-
off distance: OEM configuration parameter:
cfgGlobalPrperties-threadliftoff)
 Feed rate override is not effective
 Create thread with G95 (feed rate per revolution)
Cycle run
1
Accelerates to feed rate (line B).
2 Moves at feed rate to end point of thread –run-out length P.
3 Decelerates (line P) and stops at the end point of thread.
Parameters
X
Max. positive offset: Limit in +X
Z Max. positive offset: Limit in +Z
U Max. negative offset: Limit in –X
W Max. negative offset: Limit in –Z
H Reference direction:
 H=0: Longitudinal thread
 H=1: Transverse thread
Q Thread type:
 Q=1: Right-hand thread
 Q=2: Left-hand thread