HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 347)

HEIDENHAIN MANUALplus 620, CNC PILOT 640 347
4.25 Lat
e
ra
l surf
ace mac
h
ining
Circular arc on lateral surface G112/G113
G112/G113 moves the tool in a circular arc at the feed rate to the "end
point."
Beispiel: G112, G113
. . .
N1 T8 G197 S1200 G195 F0.2 M104
N2 M14
N3 G120 X100
N4 G110 C0
N5 G0 X110 Z5
N7 G110 Z-20 CY0
N8 G111 Z-40
N9 G113 CY39.2699 K-40 J19.635 [circular arc]
N10 G111 Z-20
N11 G112 CY0 K-20 J19.635
N13 M15
Parameters
Z
End point
C End angle—for angle direction, see graphic support window
CY End point as linear value (reference: unrolled reference
diameter G120)
R Radius
K Center
J Center point as linear value (referenced to unrolled G120
reference diameter)
W Center of angle (for angle direction, see graphic support
window)
X End point (diameter value)—(default: current X position)
Parameters for contour description (G80)
AN
Angle to positive Z axis
BR Chamfer/rounding. Defines the transition to the next contour
element. When entering a chamfer/rounding, program the
theoretical end point.
 No input: Tangential transition
 BR=0: No tangential transition
 BR>0: Radius of rounding
 BR<0: Width of chamfer
Q Point of intersection. End point if the line segment intersects a
circular arc (default: 0):
 Q=0: Near point of intersection
 Q=1: Far point of intersection
Using the parameters AN, BR and Q is only allowed if the
contour description is concluded by G80 and used for a
cycle.
Programming:
 Z, C, CY: Absolute, incremental, or modal
 K, W, J: Absolute or incremental
 Program either Z–C or Z–CY and K–J
 Program either center or radius
 For radius: Only arcs <= 180° are possible