HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 320)

320 DIN Programming
4.21 Under
c
ut cy
cles
Undercut according to DIN 76 with cylinder
machining G853
G853 machines the adjoining cylinder, the undercut, and finishes with
the plane surface. It also machines a cylinder start chamfer when you
enter at least one of the parameters Cut-in length (1st cut length)
or Cut-in radius (1st cut radius).
Parameters that are not programmed are automatically calculated by
the Steuerung from the standard table:
 FP from the diameter
 I, K, W, and R from FP (thread pitch)
Blocks following the cycle call
Beispiel: G853
%853.nc
[G853]
N1 T2 G95 F0.23 G96 S248 M3
N2 G0 X60 Z2
N3 G853 FP1.5 I47 K15 W30 R2 P1 B5 RB2
WB30 E0.2 H1
N4 G0 X50 Z0
N5 G1 Z-30
N6 G1 X60
N7 G80
END
Parameters
FP
Thread pitch
I Undercut depth (default: value from standard table)
K Undercut length (default: value from standard table)
W Undercut angle (default: value from standard table)
R Undercut radius (default: value from standard table)
P Oversize:
 P is not defined: The undercut is machined in one pass
 P is defined: Division into pre-turning and finish-turning
– P = longitudinal oversize; the transverse oversize is preset
to 0.1 mm
B Cut-in length (1st cut length)—no input: No chamfer machined
at start of cylinder
RB Cut-in radius (1st cut radius)—no input: 1st cut radius is not
machined
WB 1st cut angle (default: 45 °)
E Reduced feed for machining the undercut (default: active feed
rate)
H Type of departure (default: 0):
 0: Tool returns to the starting point
 1: Tool remains at the end of the plane surface
N.. G853 FP.. I.. K.. W.. /Cycle call
N.. G0 X.. Z.. /Corner point of cylinder start chamfer
N.. G1 Z.. /Undercut corner
N.. G1 X.. /End point on plane surface
N.. G80 /End of contour definition
 Undercuts can only be executed in orthogonal, paraxial
contour corners along the longitudinal axis.
 Cutting radius compensation is active.
 Oversizes are not taken into account.