HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 250)

250 DIN Programming
4.1
0
Linear and cir
c
ular mo
v
e
ments
4.10 Linear and circular movements
Linear movement G1
G1 moves the tool on a linear path at the feed rate to the "end point."
Parameters
X
End point (diameter)
Z End point
AN Angle (angular direction: see help graphic)
Q Point of intersection. End point if the line segment intersects a
circular arc (default: 0):
 0: Near point of intersection
 1: Far point of intersection
BR Chamfer/rounding. Defines the transition to the next contour
element. When entering a chamfer/rounding, program the
theoretical end point.
 No input: Tangential transition
 BR=0: No tangential transition
 BR>0: Radius of rounding
 BR<0: Width of chamfer
BE Special feed factor for chamfer/rounding arc (default: 1)
Special feed rate = active feed rate * BE (0 < BE <= 1)
Programming X, Z: Absolute, incremental, modal or "?"
If more axes are available on your machine, additional
input parameters will be displayed, e.g. parameter B for
the B axis.