HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 84)

84 smart.Turn units
2.5 Units—Dr
illing in C axis
2.5 Units—Drilling in C axis
"Single hole, face" unit
This unit machines a hole on the face of the workpiece.
Unit name: G74_Bohr_Stirn_C / Cycle: G74 (see page 331)
Access to the technology database:
 Machining operation: Drilling
 Affected parameters: F, S
Cycle form
Z1
Start point drill (starting point of hole)
Z2 End point drill (end point of hole)
CS Spindle angle
E Delay (dwell time at end of hole) (default: 0)
D Retraction at
 0: Rapid traverse
 1: Feed rate
V Feed rate reduction
 0: Without reduction
 1: At end of the hole
 2: At start of the hole
 3: At start and end of the hole
AB Spot drilling / through drilling length – distance for feed rate
reduction
P Hole depth
IB Hole depth reduction value: Value by which the feed depth
decreases after every advance.
JB Minimum hole depth: If you have entered a hole depth
reduction value, the hole depth is reduced only to the value
entered in JB.
B Retraction distance: Value by which the tool is retracted
after reaching the respective hole depth.
RI Internal safety clearance: Distance for reapproach inside
the hole (default: safety clearance SCK).
"Global" form
G14
Tool change point
 No axis
 0: Simultaneously
 1: First X, then Z
 2: First Z, then X
 3: Only X
 4: Only Z
 5: Only Y direction
 6: Simultaneous with Y (X, Y and Z axes move on a
diagonal path)