HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 450)

450 DIN Programming
4.38 F
u
ll-surf
ace mac
h
ining
Full-surface machining with single spindle
G30: Normally not required
G99: The expert program mirrors the contour. Further programming of
G99 is normally not required for machining the rear face after
rechucking.
Example: The front and rear face of the workpiece are machined using
one NC program. The workpiece is first machined on the front face;
then it is rechucked manually. The rear face is machined
subsequently.
The expert program mirrors and shifts the contour for the 2nd setup.
Full-surface machining on machine with one spindle
HEADER
#MATERIAL STEEL
#MEASURE_UNITS METRIC
TURRET
T1 ID "512-600.10"
T2 ID "111-80-080.1"
T4 ID "121-55-040.1"
BLANK
N1 G20 X100 Z100 K1
FINISHED
. . .
FACE_C Z0
. . .
REAR_C Z-98
N20 G308 ID"R" P-1
N21 G100 XK5 YK-10
N22 G101 YK15
N23 G101 XK-5
N24 G103 XK-8 YK3.8038 R6 I-5
N25 G101 XK-12 YK-10
N26 G309
MACHINING