HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 164)

164 smart.Turn units
2.1
1
Units—Special oper
ations
"Program end" unit
In every smart.Turn program, the end unit should be called once at the
end of the machining section.
Unit name: END / Called cycle: None
"Program end" form
ME
Type of return jump
 30: Without M30 restart
 99: With M99 restart
NS Block number for return jump
G14 Tool change point
 No axis (do not approach the tool change point)
 0: Simultaneous (X and Z axes depart diagonally)
 1: First X, then Z
 2: First Z, then X
 3: Only X
 4: Only Z
 5: Only Y
 6: Simultaneous with Y
MFS M command at the start of the unit
MFE M command at the end of the unit