HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 170)

170 smart.Turn units for the Y axis
3.1 Units—Dr
illing in the Y axis
"ICP boring/countersinking, Y axis" unit
The unit machines a single hole or a hole pattern in the XY or YZ plane.
Using ICP, you define the hole positions as well as further details for
boring or countersinking.
Unit name: G72_ICP_Y / Cycle: G72 (see page 327)
Access to the technology database:
 Machining operation: Drilling
 Affected parameters: F, S
Parameters on the Pattern form
FK
see page 62
NS Starting block no. of contour
Parameters on the Cycle form
E
Delay (dwell time at end of hole) (default: 0)
D Retraction at
 0: Rapid traverse
 1: Feed rate
RB Retraction plane (default: return to the starting position or
to the safety clearance)
Further forms: see page 60