Grass Valley EDIUS Neo 2 - Manual (Page 574)

574 EDIUS Neo — User Reference Guide
Appendix B — Special Procedures
9. Move the End image if desired by positioning the cursor over the
square in the middle of the image (an orange outline around the square
will appear). Click and drag the square to the new center location for
the End frame.
Note Be careful not to click anywhere except the square in the center of the image
or you will add another keyframe position. If you need to delete a keyframe
position, right-click on the center square (the orange outline appears) and
select ‘Delete” from the menu or press the [DELETE] key on the keyboard.
As illustrated in Figure 723 , there are several layout options on the right-
click menu which affect the selected keyframe. These may be used to set the
keyframe position.
Figure 723. Keyframeable 2D PIP - Right-Click Layout Menu
10. Move the Timeline cursor back and forth to see the image move and
scale between the Start and End points. Make any adjustments that
need to be made in image size or Start and End position.
11. Add a third keyframe position at a point between the Start and End
position by clicking at the desired location.
12. Move the Timeline cursor to the center of the clip.