Grass Valley EDIUS Neo 2 - Manual (Page 287)

EDIUS Neo — User Reference Guide 287
Timeline Clip Operations
Source Crop
Using the source crop settings, the area to be cropped is defined based on
the original clip parameters.
Left
Based on the original clip width, designate the percentage of the area on
the left of the clip to be cropped and not displayed.
Top
Based on the original clip height, designate the percentage of the area
on the top of the clip to be cropped and not displayed.
Right
Based on the original clip width, designate the percentage of the area on
the right of the clip to be cropped and not displayed.
Bottom
Based on the original clip height, designate the percentage of the area
on the bottom of the clip to be cropped and not displayed.
Note After entering crop percentages, the number of pixels to be cropped from
each side of the clip is calculated and displayed.
Anchor
Designates the X,Y position of the display in the Timeline Preview window.
The “Anchor Position” is the starting point for Source Crop operations
explained above.
Position - Area Selection
From the drop-down list select the desired display area as indicated in
Figure 337 :
• Underscan Area
• Overscan Area
• Title Safe Area