Grass Valley EDIUS Neo 2 - Manual (Page 298)

298 EDIUS Neo — User Reference Guide
Section 5 — Timeline Operations
Note You can fine tune trimming by 1-frame or 10-frame units by using the trim
buttons in the trim window or the corresponding keyboard shortcuts. See
Trim Mode Operation Buttons
on page 296 for more details.
When selecting a trim point that is at the end of one clip and the beginning
of another, two sets of cut points appear as illustrated in
Figure 347 . Click
the cut point to be active for trimming. The active cut point is yellow.
Figure 347. Cut Points Between Clips
Alternative Method:
1. Click the track where the clip to be trimmed is placed.
2. Move the Timeline Cursor to the point to which the clip should be
trimmed.
3. Press the appropriate shortcut key to trim from the beginning of the clip
to the cursor position or from the end of the clip to the cursor position:
• [ N] - trim from the beginning of the clip to the cursor position.
• [ M ] - trim from the end of the clip to the cursor position. See Figure 348
for an example of this action.