Grass Valley EDIUS Neo 2 - Manual (Page 239)

EDIUS Neo — User Reference Guide 239
Clip Placement
In/Out Points
These points mark the In and Out points of the content that should be
included in the project output. They also limit the range over which certain
operations are executed.
Markers
Markers serve as chapter points when the project is output using Burn to
Disc. Markers are also used to designate points on the Timeline for quick
navigation.
Timeline Cursor
The Timeline cursor marks the position on the Timeline of the frame dis-
played in the Recorder. The cursor may be freely dragged to the left or the
right to change its position.
Timeline Scale Settings
The time scale on the Timeline can be displayed in units ranging from 1
Frame to 60 minutes. The entire project may also be displayed without
scrolling by automatically adjusting the Timeline scale to “Fit” the project.
For information on adjusting the Timeline scale, see Timeline Scale on
page 62
Clip Placement
In and Out Points
When working with clips on the Timeline, it is often desirable to set In and
Out points in order to use only a portion of the clip or to limit the range over
which certain operations are executed.
Setting In and Out Points on Timeline
Setting In and Out points on the Timeline allows you to restrict the range
in which certain operations will take place, or to position a clip in the Time-
line based on the In and Out points.
To set In and Out points on the Timeline, do the following:
1. Move the Timeline cursor to the position at which you wish to set the
In point. Refer to
Figure 273 .