Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 89)

Phoenix 9.76.0 Installation and Setup Manual 806410 89
2 – Machine Setup
Dialog Prompt: Enter the ASCII code equivalent to the character or symbol used by the host computer for dialog
prompt.
Dialog Pause: Enter the ASCII code equivalent to the character or symbol used by the host computer for dialog pause.
Rewind: This field is only enabled when Link File Dump Mode has been enabled. Enter the ASCII code equivalent to the
character or symbol used by the host computer for tape rewind at the host tape drive system. Enter 0 to
eliminate the rewind command.
The following additional parameters are available when Serial Messaging has been enabled. For more information see
Serial Messaging in the Phoenix V9 Series Programmer’s Reference (806420).
Flow control: Select None, Xon/Xoff or Hardware.
During Jog on Path: Select whether the CNC sends messages when jogging Forward or Backward on Path while at
the Pause screen.
Notes:
 All messaging stops when the Stop Key has been pressed or when the Remote Pause input becomes active.
 The Message Type 21 is not executed for Backup on Path.
Retry on Time Out: Select the number of times the system automatically retries Message Type 22. After the system tries
to send the message this many times it displays “Message Error” to indicate that the external device does
not respond.
Time Out: This value is used for Message Type 22 if there is no time-out value used in the command string of the
program code. For more information, refer to the Time Out/Transmit Delay parameters.