Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 134

Text mode
Original mode

134

Phoenix 9.76.0 Installation and Setup Manual 806410

5 – Station Setup

The following picture shows an example of the Auto Select and Manual Select inputs, and Station Enable LED outputs
and additional I/O for a two-torch operator console and control box.

Note: This is an example only and not intended as a recommendation for system design.

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2