Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 188

188

Phoenix 9.76.0 Installation and Setup Manual 806410

8 – Diagnostics

To test the operator console:

1. From the Main screen, select Setups > Diagnostics > Operator Interface.

2. To test the USB port, touch it on the picture on the Operator Interface screen then follow the instructions on the

screen.

3. To test the lights for Station 1 or 2, touch the corresponding light on the picture on the Operator Interface screen

then follow the instructions on the screen.

4. You can also operate any component on the front panel of the CNC and watch the corresponding component on the

screen. Verify that the operation of the component on the screen matches what you do on the panel

If the test for a single component fails, replace that component. If multiple components fail, contact your OEM or system
integrator to replace the ribbon cable to the front panel board, the front panel board, or both.

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2