Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 284)

284 Phoenix 9.76.0 Installation and Setup Manual 806410
16 – Waterjet Application
The CNC identifies each state of the cut sequence with a blue status message below the part preview area on the Main
screen.
State and status message: Head Down
Initiated when: The CNC reads the M07 code (Cut On) in the part program and the Head Down timer is
set in the Waterjet Process screen. The Head Down timer elapses before Cut Control output turns on.
State and status message: Abrasive Delay
Initiated when: The CNC turns on the Cut Control output and when the Abrasive On Delay timer, which is
set in the Waterjet Process screen, elapses, the Abrasive Control output turns on.
State and status message: Pierce Motion Delay
Initiated when: The CNC starts the Pierce Motion Delay timer after the Abrasive On Delay elapses.