Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 198)

198 Phoenix 9.76.0 Installation and Setup Manual 806410
8 – Diagnostics
For a Picopath system, connect the brown tester to the Joystick/Speedpot port, the X/Y port and the I/O port.
3. On the Machine Interface screen, choose Test. A message informs you if the test is successful.
If the test fails, contact your OEM or system integrator to check or replace these parts in the following order:
1. Analog field interface card
2. Ribbon cable
3. Analog interface card