Enabling the waterjet process on the cnc – Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 281

background image

Phoenix 9.76.0 Installation and Setup Manual 806410

281

16 – Waterjet Application

Enabling the waterjet process on the CNC

Use the Special Setups screen to enable the waterjet process and make the Waterjet Process screen available.

1. Choose Setups > Password > Special Setups.

2. Select Waterjet under Tools Installed.

3. Choose OK.

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2