Sercso ii setup screen – Hypertherm V9 Series Phoenix Rev.11 User Manual
Page 129
Phoenix 9.76.0 Installation and Setup Manual 806410
129
4 – SERCOS setup
SERCSO II setup screen
Choose Setups > Password > Machine Setups > SERCOS to open the setup screen.
Drive Type: Select the manufacturer of the SERCOS style drive. This makes the proper operation and tuning parameters
and software available.
Update Rate: Select the motion and I/O update rate for the SERCOS ring. One millisecond is recommended but the
actual value depends on the capabilities of the hardware being used.
Baud Rate: Select the communication rate for the SERCOS ring. This is determined by the type of drive and I/O being
used.
Light Level: Adjust the intensity of the light pulses used on the fiber optic ring. This feature compensates for diminished
signal due to issues such as ring distance.
Drive I/O: Select the I/O options that are supported on the drive amplifier; None, Overtravel and Home Switches, or All
I/O.
The drive I/O populates the general purpose I/O (both analog and digital) in order from
the lowest SERCOS drive axis to the highest SERCOS drive axis. All I/O is the default
setting for the SMCC interface.