Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 196)

196 Phoenix 9.76.0 Installation and Setup Manual 806410
8 – Diagnostics
2. Follow the instructions on the screen to connect the THC test cable to the THC port you selected and to the Axis
1 – 2 port (Hypath) or X/Y port (Picopath). Use the blue tester for Hypath and the yellow tester (not shown) for
Picopath.
3. On the Machine Interface screen, choose Test. A message informs you if the test is successful.
If the test fails, contact your OEM or system integrator to check or replace these parts in the following order:
1. Analog field interface card
2. Ribbon cable
3. Analog input card