Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 153)

Phoenix 9.76.0 Installation and Setup Manual 806410 153
7 – Plasma Setup
Sample settings for a multiple-torch cutting system
To set up a multiple-torch HPR Auto Gas system that uses one cutting process and one marking process for all torches,
follow these general steps on the CNC:
First, in the Special Setups screen, select Plasma 1 and Marker 1. Plasma 2 is a separate process and is not used in this
example.
In the Station Configuration screens shown below, all four cutting stations have the HPR assigned to Plasma 1 and
Marker 1. In this screen you are assigning the cutting and marking processes that will be used for each of the individual
cutting stations.
If all torches are always going to cut and mark with the same consumable sets, then the assignment is Plasma 1 and
Marker 1 for all cutting tools.
Choose this soft key to advance to
the screen for Stations 3 and 4.
Station 1 and
Station 2