Connecting the cnc to a network (non-dhcp) – Hypertherm V9 Series Phoenix Rev.11 User Manual
Page 234
234
Phoenix 9.76.0 Installation and Setup Manual 806410
11 – Networking
Connecting the CNC to a Network (non-DHCP)
If you are not using a DHCP Server, you will need the following internet protocol network settings. Enter them in the table
below for future reference:
In a non-DHCP network you will need to access the network setting screen and change the internet protocol settings to
make the CNC compatible with the network.
1. Press Alt+F4 to exit Phoenix.
2. Choose Start > Settings > Network Connections.
3. Double-click the active network connection in the list. The status window for the connection opens.
IP Address
Subnet Mask
Default gateway
Preferred DNS server
Alternate DNS server
Will the CNC be part of a workgroup?
Name of the workgroup
Has the operator’s user name and password been
added to the server?