Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 123)

Phoenix 9.76.0 Installation and Setup Manual 806410 123
Section 4
SERCOS setup
Hypertherm CNCs support both SERCOS II (fiber optics) and SERCOS III (Ethernet) communication protocols.
 See SERCOS II support on page 127 for information on SERCOS II.
 See the Field Service Bulletin SERCOS III for Hypertherm CNCs (808000) for setup information for SERCOS III
drives. This Field Service Bulletin is provided with all SERCOS III-enabled Hypertherm CNCs and is available in the
Downloads Library at Hypertherm.com.
SERCOS III support
SERCOS III is a real-time communication bus for digital servo drives designed for high-speed communications over
industrial Ethernet cable. Hypertherm CNCs with Phoenix software version 9.74.1 or higher support the following
SERCOS III equipment.
Drives
 Bosch IndraDrive Cs Basic with multi-Ethernet support, drive firmware type MPB, and firmware version 16V24,
17V14 or later, and 18V06 or later.
 For best performance, use the IndraDrive Cs Basic drive instead of the economy drive.
The economy drive requires a 2 ms servo loop update rate (also called the
cyclic rate)
instead of the 1 ms update rate.
 Kollmorgen AKD drives with the following part number format: AKD-PXXXXX-NBS3-XXXX where NBS3 designates
the drive with firmware compatible with Phoenix 9.74.0.
Bus couplers
Bosch I/O bus coupler and I/O modules (listed by part number):
 R-IL S3 BK DI8 DO4-PAC – SERCOS III bus coupler, 8 digital inputs, 4 digital outputs, 500 mA
 R-IB IL AO 2/U/BP-PAC – Analog output module, 2 analog outputs, 2-wire connection
 R-IB IL AI 2/SF-PAC – Analog input module, 2 analog inputs, 2-, 3-wire connection