Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 191)

Phoenix 9.76.0 Installation and Setup Manual 806410 191
8 – Diagnostics
3. On the Machine Interface screen, press Test. A message informs you if the test is successful.
In the event of a test failure, contact your OEM or system integrator with the following information:
 Serial 1 or 2 failure: replace motherboard.
 Serial 3 or 4 failure: replace serial isolation card.
USB Test
Conduct this test if the memory stick is not shown as an option when you try to load part programs or update cut charts,
software, or help. Use this test to check all the USB ports: the four on the back and the one on the front of the
MicroEDGE Pro.
To test the USB port:
1. On the Machine Interface screen, choose a USB port.