Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 275

Text mode
Original mode

Phoenix 9.76.0 Installation and Setup Manual 806410

275

15 – Oxyfuel Application

When adjusting the gas pressures or timers, use the Apply soft key to send the pressures to the cutting system. As you
are fine-tuning the system for your requirements, you can select Apply, change the pressures on the screen, and select
Apply again without exiting the screen.

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2