Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 277)

Phoenix 9.76.0 Installation and Setup Manual 806410 277
15 – Oxyfuel Application
The following table illustrates the output activation for the three modes. When you run the part, the Creeping message
displays as the status when the I/O that are associated with these parameters activate.
Mode 1 Mode 2 Mode 3
Staged Pierce Output
(number) = (state)
Staged Pierce Output
(number) = (state)
Staged Pierce Output
(number) = (state)
Torch reaches creep
speed 1 = On
2 = Off
3 = Off
4 = Off 1 = On
2 = Off
3 = Off
4 = Off 1 = On
2 = Off
3 = Off
4 = Off
Staged Pierce Time 1
expires 1 = On
2 = On
3 = Off
4 = Off 1 = On
2 = On
3 = Off
4 = Off 1 = Off
2 = On
3 = Off
4 = Off
Staged Pierce Time 2
expires 1 = On
2 = On
3 = On
4 = Off 1 = On
2 = On
3 = On
4 = Off 1 = Off
2 = Off
3 = On
4 = Off
Staged Pierce Time 3
expires 1 = On
2 = On
3 = On
4 = On
Torch accelerates to cut
speed
1 = Off
2 = Off
3 = Off
4 = On
Torch accelerates to cut
speed
1 = Off
2 = Off
3 = Off
4 = On
Torch accelerates to cut
speed
At end of Staged
Pierce All Staged Pierce outputs
remain on until the end of the
cut (M08)
Staged Pierce output 4
remains on until the end of the
cut (M08)
Staged Pierce output 4
remains on until the end of the
cut (M08)