Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 127)

Phoenix 9.76.0 Installation and Setup Manual 806410 127
4 – SERCOS setup
SERCOS II support
The CNC supports either SERCOS II (fiber optic) or SERCOS III (Ethernet) communication interfaces. The previous
section,
SERCOS III support provides more information on SERCOS III.
Drives
 Indramat/Bosch
 IndraDrive Mi
 IndraDrive C basic drive
 IndraDrive C basic drive with MA1 option
 IndraDrive C advanced drive
 IndraDrive C advanced drive with MA1 option
 IndraDrive M Double Drive (I/O on drives is not supported)
 EcoDrive 03
 EcoDrive Cs
 Kollmorgen
 ServoStar 300
 Kollmorgen/Danaher
 ServoStar 600
 SSCD
 Yaskawa
 Sigma II with TRIO SERCOS adapter
 PacSci
 PC840 Series
I/O bus couplers and I/O modules
I/O bus couplers
 Beckhoff SERCOS II BK7520 (has preferred higher baud rate)
 Beckhoff SERCOS II BK7500
 Bosch SERCOS II Reco
 Reco 02.2 SERCOS node
 1 Beckhoff SERCOS node
 1 Hypertherm Automation I/O SERCOS node
 A single Hypertherm Automation I/O node can be configured with either 1 Reco or 1
Beckhoff node. No more than one Reco or Beckhoff I/O node can be enabled.