Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 52

Phoenix 9.76.0 Installation and Setup Manual 806410

2 – Machine Setup

The X axis is the first axis Phoenix needs to know about. In a standard orientation, the X axis would be along the gantry.
Phoenix calls the axis along the gantry the Transverse axis. The Y axis is always perpendicular to the X axis. In Phoenix, the
Rail axis is perpendicular to the Transverse. In a standard orientation the Y axis would be along the rail. When a cutting
system has a second rail motor, you select the Dual Gantry axis on the Machine Setups screen in Phoenix.

The following picture shows a cutting table where X is assigned to the gantry, also called Transverse, and Y is assigned to
the Rail.

0, 0

-X

-Y

Gantry

Rail

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2