Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 149)

Phoenix 9.76.0 Installation and Setup Manual 806410 149
6 – Special Setups
True Hole I/O Verification: Checks for these outputs: Pierce Control, Pierce Control 1 – 20, or Pierce Control
THC 1 – 4.
Torch Height Disable: Checks that no Station Select inputs are assigned.
True Hole Setups Verification: Checks for the following parameters and settings:
 EIA Kerf Override – Enabled
 EIA F-code Override – Enabled
 EIA G59 code Override – Enabled
 Process Select Override – Enabled
 Parallel Kerf Enabled – Disabled
 Arc Off Time ≥ .05 seconds
 Cut Off Time = 0
 If Auto Select Inputs AND Manual Select Inputs are assigned: Station Select Override – Enabled
For Command THC:
 Nozzle Ohmic Contact – Off
 Retract Delay > .22 seconds
 Pierce On with Cut On – Yes
For Sensor THC:
 Pierce on with Cut On – Yes
For Arc Glide THC:
 Use Pierce Complete – On
True Hole OpCon Verification: Checks the operator console switches:
 If any Auto Select inputs are assigned, then at least one station must be set to Program.
 Program speed set to 100%
Invalid process current selected: In the cut chart, you have selected a process current that is not valid for that is not
supported.
Jog key watch warning: An option for Watch Window setup is to display manual-motion jog keys on the CNC
touchscreen. However, if the CNC is installed in an environment where water droplets could come into
contact with the touchscreen, unintended motion could occur. This warning displays when setting up a
Watch Window with jog keys.
Verify lens installed and Verify nozzle installed: These messages may appear after a you have changed the cut
chart and the new cut chart requires a different nozzle or lens.
Soft Keys
Save Setups: Press the Save Setups button to save the current CNC setting to the USB drive or hard drive. A window
displays to select the drive and enter a file name.
Note: After installation of the CNC on the cutting table or if any setup parameters are changed, it is important to
save the current setup file to both the hard drive and USB drive for future reference.