Oxyfuel cut chart – Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 271

Text mode
Original mode

Phoenix 9.76.0 Installation and Setup Manual 806410

271

15 – Oxyfuel Application

Oxyfuel cut chart

The CNC provides cut charts for oxyfuel cutting systems. The cut charts are specific to the type of torch used on the
oxyfuel cutting system.

If your cutting system is using proportional regulators on analog inputs (described in the next section), the gas pressures
in the cut chart are transferred to the Oxyfuel Process screen.

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2