Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 139

Text mode
Original mode

Phoenix 9.76.0 Installation and Setup Manual 806410

139

5 – Station Setup

The cause of the error in the this example is that Station 1 does not have a laser process assigned to the station and the
station was active when attempting to cut with the Laser process. If station 1 was Off the error would not have occurred.

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2