Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 205)

Phoenix 9.76.0 Installation and Setup Manual 806410 205
8 – Diagnostics
The Norton Ghost Utility works by allowing you to retrieve an image file from the drive D: partition of the hard drive to
replace all data on drive C: The Ghost Image can be a factory default or custom, user-created image files.
 All current information on Drive C: will be lost. You should create a unique user image after table configuration which
includes all the important table settings.
This feature may be executed from the System Tools screen or through use of a Ghost image utility. This tool is available
from the CNC supplier and transmitted over the Internet.
 Create Utility from E-mail – To create a Norton Ghost tool utility from the compressed software sent via the Internet.
 USB Memory – Instructions to download USB format tools and files are available to create a bootable USB device.
Specific batch files to run the utility are included.
Creating a Ghost Recovery File
To create a Custom Image File:
1. Place the Norton USB memory device into the CNC.
2. Turn the CNC on. Norton Ghost displays:
Starting PC DOS.......
Select 1 to make a New Backup Image or 2 to restore existing [1,2]
3. Press 1 to create a new back up image.
You can create up to three custom images. They are created as “newest” to “oldest” image and are automatically
assigned. The “original” ghost image is the factory default and cannot be over written. Back up begins automatically:
--------------Backing Up Drive, Please Wait ---------------
The following Message appears when the backup is complete:
---- Back Up Complete, Please Remove Disk and Reboot -----
1. Remove the USB memory device.
2. Turn the CNC off and then on. You may need to load a setup file and update the Phoenix software if the image is not
current.