Setting up analog outputs – Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 273

Text mode
Original mode

Phoenix 9.76.0 Installation and Setup Manual 806410

273

15 – Oxyfuel Application

Setting up analog outputs

The CNC provides 0 to 10 VDC reference voltage for the analog outputs. For each analog output you will need to enter
the maximum regulator pressure. The CNC then calculates the voltage to correspond to pressure settings from 0 to the
maximum pressure. There is no feedback to the CNC to control accuracy.

1. Select Setups > Password > Machine Setups > I/O.

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2