Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 189)

Phoenix 9.76.0 Installation and Setup Manual 806410 189
8 – Diagnostics
MicroEDGE Pro Machine Interface Tests
The Phoenix software provides a series of diagnostic tests for the Hypertherm MicroEDGE Pro CNC. These tests require
the following test hardware:
Note:
 For MicroEDGE Pro with SERCOS, use kit 228831.
 Kits 228832 and 228833 both include the serial, USB, and LAN/Hypernet testers.
 If you are using the keyboard-only interface on the CNC (No Touchscreen Installed is selected in the Special
Setups screen) you cannot perform the machine interface tests as described in this section unless you have a
mouse installed on one of the USB ports.
To begin an interface test:
1. From the Main screen, choose Setups > Diagnostics > Machine Interface.
2. Enter the Machine password.
3. On the Machine Interface screen, choose the connector you want to test on the image of the CNC.
Connector test hardware Kit part number
Serial port – RS-232 (motherboard)
Serial port – RS-422/RS-232 (serial isolation board) 228831
USB port 228831
LAN/HyperNet 228831
HyPath I/O – 1 st tester (green stripe)
HyPath I/O – 2 nd tester (red stripe)
228832
HyPath axes (green) 228832
HyPath THC (blue) 228832
HyPath joystick/speedpot (purple) 228832
Picopath I/O – 1 st tester (orange stripe)
Picopath I/O – 2 nd tester (white stripe)
228833
Picopath axes (blue) 228833
Picopath THC (yellow) 228833
Picopath joystick/speedpot
(brown stripe) 228833