Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 148)

148 Phoenix 9.76.0 Installation and Setup Manual 806410
6 – Special Setups
Status/Message or Wizard List
To change the status of a message, highlight the selected message and press the Space key.
Ready to Start Cutting: When enabled, the Ready Message feature will display a ready message when the Start button
is pressed.
Kerf Too Large Warning: Disables the Kerf Too Large warning message. This message notifies the user that a conflict
between the cut paths and the current Kerf value for a part has been detected and that some detail could be
lost when the part is cut.
Homing Must Be Performed: Prompts the operator to home the selected axis before motion begins. The selected axis
must have homing enabled on the axes setup screen.
Values Have been Changed: Displays as a confirmation when changes to values on the current configuration screen
are detected. This ensures that changes are not made in error when exiting the screen.
Home Torch Height Control: Prompts the operator to home the Sensor THC axis at power up and before motion
begins.
Ready to Final Align: Appears as part of the skew alignment function and displays just before final motion to position
the tool begins.
Part Larger than Plate: Displays when the dimensions of the part that have been loaded exceed the selected plate
dimensions.
Cut Chart Data Has Changed: Displays as a confirmation when changes to the values on the current Cut Chart screen
are detected. This ensures that changes are not made in error when exiting the screen.
Save Part for Rush Job: Enables or disables the Resume Part prompt for Rush Job Interrupt.
Torch Already Raised/Lowered: Appears when the torch is fully raised or lowered.
Automatic Align Wizard: Enables or disables the automatic availability of the alignment wizard on the Align screen.
Automatic CutPro Wizard: Enables or disables the automatic availability of the Cut Pro wizard on the Main screen. If
availability of the wizard is enabled, it appears 10 seconds after the Main screen is opened.
Start Cut from CutPro Wizard: Allows or prevents cutting to start directly from the Cut Pro Wizard. If this is disabled,
the operator must use the Start button on the console to begin the cut.
True Hole Verification: On a True Hole cutting system, Phoenix can perform a series of checks to help ensure that the
correct settings are made for True Hole cutting. You can enable or disable these checks individually. When
enabled, Phoenix can automatically correct many of these settings.