Hypertherm V9 Series Phoenix Rev.11 - Manual (Page 282)

282 Phoenix 9.76.0 Installation and Setup Manual 806410
16 – Waterjet Application
Selecting the waterjet pump model
Select the waterjet pump model to enable the cut chart and activate the pump manual on the help screen.
1. Choose Setups > Password > Station Configuration.
2. For Waterjet, choose HyPrecision.
3. Choose the cutting head supported by your waterjet system.
4. Choose OK.
Serial communications
If the waterjet pump is equipped with the remote communication option, the CNC can communicate with the pump PLC
through an RS-422 serial link. These types of messages are exchanged between the CNC and the PLC:
 Cut pressure
 Low pressure (used for piercing certain materials)
 Pump warnings
 Pump errors