System tools, Introduction – Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 37

Text mode
Original mode

Phoenix 9.76.0 Installation and Setup Manual 806410

Section 1

System Tools

Introduction

The Phoenix software offers a suite of tools for performing system-level tasks such as backing up the CNC hard drive and
connecting the CNC to a network. To access the Phoenix system tools, choose Setups > Password > Special Setups
> System.

Before you begin, connect a mouse and keyboard to the CNC to use System Tools.

CAUTION

Using the System Tools requires operational knowledge of the Windows

operating system

and should only be performed by qualified personnel.

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2