Serial communication interface, Rs-422c connections to hpr cnc interface, Powermax plasma supply – Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 164

164

Phoenix 9.76.0 Installation and Setup Manual 806410

7 – Plasma Setup

Serial communication interface

RS-422C connections to HPR CNC interface

Powermax plasma supply

Hypertherm CNCs support a serial connection to the Powermax65

, Powermax85

, and Powermax105

. From the CNC

you can set cut mode (normal cutting or continuous pilot arc), current, and gas pressure. A diagnostic screen helps you
monitor the status of the Powermax system.

Setting up a Powermax system in Phoenix requires the following steps:



Select the Powermax65 or Powermax85 in the Station Configuration screen.



Assign the Powermax to a serial port.



Assign I/O for the Powermax.

Selecting the Powermax in the Station Configuration screen

1. Choose Setups > Password and enter your password to open the Station Configuration screen.

2. For Station 1 (or the station you want to set up for the Powermax), choose your Powermax model from the drop-down

list.

Control (male)

Supply (male)

Signal name

DB-9 pin

Signal name

DB-37 pin

TxD-

RxD-

TxD-

TxD+

RxD+ 20

RxD+

TxD+ 21

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2