The cause of the error – Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 143

Text mode
Original mode

Phoenix 9.76.0 Installation and Setup Manual 806410

143

5 – Station Setup

The cause of the error

Marker 1 is assigned to Station 2 in the Station Configuration screen and no station I/O is assigned for Station 2 which
makes Station 2 active within Phoenix. The Station Enable LED 2 output becomes virtual and forced to ON if a process is
assigned to a station and no station I/O is assigned.

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2