Sercos setup screen – Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 126

Text mode
Original mode

126

Phoenix 9.76.0 Installation and Setup Manual 806410

4 – SERCOS setup

SERCOS setup screen

The CNC requires that the drive I/O or inline bus coupler I/O be enabled. Choose Setups > Password > Machine
Setups > SERCOS to open the setup screen.

Drive I/O: Select All I/O to enable the drive I/O (recommended). Select None if the drives do not have available I/O or

you do not intend to use the drive I/O.

Bosch Inline I/O at Address 50: Select Yes if you are using an inline I/O bus coupler to expand the total number of I/O

in the SERCOS ring.

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2