Back up the hard drive – Hypertherm V9 Series Phoenix Rev.11 User Manual

Page 40

Text mode
Original mode

Phoenix 9.76.0 Installation and Setup Manual 806410

1 – System Tools

Back up the hard drive

1. From the Main screen, choose Setups > Password > Special Setups.

2. Choose the System soft key.

Press the Backup Hard Drive soft key to use the Norton™ Ghost Utility to save the contents of the main hard drive to a
specified location on the CNC hard drive or to a mapped drive on the network.



After using Norton Ghost, all files on Drive C: will be replaced. Make sure to reload the Phoenix.ini file (or other setup
file) for the system.

This manual is related to the following products:

V9 Series Phoenix Rev.9 EDGE Pro HyPath Shape Cutting Control Rev.4 EDGE Pro Picopath Shape Cutting Control Rev.3 EDGE Pro SERCOS II Shape Cutting Control Rev.4 EDGE Pro SERCOS III Shape Cutting Control Rev.4 EDGE Pro Ti Shape Cutting Control Rev.2 MAXPRO200 Rev.2