Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 26)

Basic configuration of the web application
24 · G&D DVICenter
4. Enter the following data in the Parameter paragraph:
5. Click OK to save your settings.
Primary slave: Choose if the data traffic should run via Network A ( Interface A )
or Network B ( Interface B ). As soon as the selected interface is
available, the data traffic is sent via this interface.
If you choose the option None , the data traffic is sent via any
interface. The interface only changes if the active interface is
down.
Link monitoring: Choose if you want the MII or ARP mode (description see
below) to be used to monitor the interface.
MII down delay: Time delay in milliseconds before a failed network interface
is disabled.
The value must be a multiple of 100 ms (the MII link moni-
toring frequency).
MII up delay: Time delay in milliseconds before a reset network interface is
enabled.
The value must be a multiple of 100 ms (the MII link moni-
toring frequency).
ARP interval: Enter the interval (100 to 10,000 milliseconds) according to
which the incoming ARP packets of the network interfaces
are to be checked.
ARP validate: The validation ensures that the ARP packet for a particular
network interface is generated by one of the listed ARP tar-
gets.
Choose if or what incoming ARP packets are to be validated:
 None: ARP packets are not validated (default).
 Active: Only the ARP packets of the active network inter-
face are validated.
 Backup: Only the ARP packets of the inactive network
interface are validated.
 All: The ARP packets of all network interfaces within the
group are validated.
ARP target: The table lists all configured ARP targets.
Use the
New , Edit, and Delete buttons to administrate the ARP
targets.