Viewing the status information of user modules, Remembering the username in the login box – Guntermann & Drunck DVICenter DP16 Config Panel User Manual
Page 109
User consoles
G&D DVICenter · 107
How to automatically disconnect the access to a target module:
1. In the directory tree, click
KVM Matrix systems > [Name] > User modules
.
2. Right-click the user console you want to configure. Now click on
Configuration
on
the context menu.
3. Click on the
General
tab.
4. Use the
Auto disconnect (min)
entry to set the time (1 to 99 minutes) for automati-
cally disconnecting the access to a target module.
5. Click
OK
to save your settings.
Viewing the status information of user modules
On the context menu of user modules you can call an interface with various status
information of the user module. This interface displays the name and also informa-
tion regarding the firmware version.
How to view the status information of user modules:
1. In the directory tree, click
KVM Matrix systems > [Name] > User modules
.
2. Right-click the user console and click on
Information
on the context menu.
3. The interface, which now opens, provides the following information:
4. Click
Close
to close this interface.
Remembering the username in the login box
If the same user often works at a certain user console, his login can be used as
default in the login box of the KVM matrix system.
After a user has logged out of the system, the login mask automatically remembers
the username of the last active user.
NOTE:
The value »0« disables the automatic disconnection when a target mod-
ule is accessed.
Name:
User module name
Device ID:
Physical ID of the user module
Status:
Current status (
on
or
off
) of the user module
Comment:
User comment about the target module
Firmware name:
Firmware name
Firmware revision:
Firmware version