Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 137)

Power switch
G&D DVICenter · 135
3. Mark the outlet you want to assign to the target module or whose assignment
you want to delete.
4. Click the button (right arrow) to assign this outlet or the button (left arrow) to
delete the assignment.
Changing the name or the comment of a power switch
How to change the name or the comment of a user module:
1. Click on KVM Matrix systems > [Name] > Power switches in the tree view.
2. Right-click the power switch you want to configure. Now click the Configuration
entry in the context menu.
3. Click on the General tab.
4. Use the Name entry to rename the power switch.
5. Use the Comment entry to change or collect any comment regarding the power switch.
6. Click OK to save your settings.
Deleting a power switch from the KVM matrix system
If the KVM matrix system is not able to detect a power switch, which already had
been connected to the system, the system defines the device as being switched off.
It is therefore necessary to manually delete the list entry of the power switch to be
permanently removed from the system.
How to delete a power switch that is inactive or disconnected from the system:
1. Click on
KVM Matrix systems > [Name] > Power switches in the tree view.
2. Right-click the power switch you want to delete and click Delete in the context menu.
3. Confirm the confirmation prompt by pressing Yes or cancel the process by
pressing No .
NOTE: Only inactive power switches can be deleted.