Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 13)

Configuring the network settings
G&D DVICenter · 11
Configuring the network settings
To access the web application, the network settings of the device on which the web
application is operated need to be configured.
How to configure the network settings before integrating the device into the local
network:
1. Use a category 5 (or better) twisted pair cable to connect the network interface of
any computer to the device’s Network A interface.
2. Ensure that the IP address of the computer’s network interface is part of the sub-
net to which the device’s IP address belongs to.
3. Switch on the device.
4. Start the computer’s web browser and enter 192.168.0.1 in the address bar.
5. Configure the network interface(s) and the global network settings as described in
the paragraph Network settings on page 21 f.
6. Remove the twisted pair cable connection between computer and device.
7. Implement the device in the local network.
NOTE: In the defaults, the following settings are pre-selected:
 IP address of network interface A: 192.168.0.1
 IP address of network interface B: address obtained using DHCP
 global network settings: settings obtained using DHCP
ADVICE: As an alternative to the steps described below, the network interfaces of a
matrix switch can also be configured via the on-screen display of a user console.
NOTE: Use the IP address 192.168.0.100, for example.
IMPORTANT: It is not possible to operate both network interfaces within one
subnet!