Guntermann & Drunck DVICenter DP16 Config Panel - Manual (Page 182)

CDS multihead groups
180 · G&D DVICenter
Requirements
 Enabled premium Tradeswitch function (see page 80).
 Established and configured Tradeswitch configuration (Workplace) (see page 159).
 Enabled CrossDisplay Switching (see page 166).
 The channels of multihead computers must not be part of channel groups (see
page 142). If necessary, delete the channel groups of the target modules you want
to configure.
 Order and size ratio of the monitors at the CDS workplace are saved in the web
application (see page 166).
 The target modules used at the individual video channels of a computer are all
individually connected to the computer via USB.
IMPORTANT: Channel groups are required to implement multihead computers
as described in the chapter Implementation of multihead monitors (see page 167).
Both CDS operating modes can be used at the same time in a KVM matrix sys-
tem. However, you can use only one operating mode per computer and per
CDS workplace.
ADVICE: When using MC user modules, you can use the temporary logon (see
OSD Operation Menu) and the rights given to your user account to log on to each
additional channel of the user module.
Afterwards, you can operate the additional video channels like an independent
channel.